For builders: shades planned before drywall
Shades are easiest when they are planned while the walls are open. We bring the details your crews need at framing, so the finish stage is a clean installation, not a repair. On custom homes and tracts across the Sacramento region and the Bay Area, we mark each opening's pocket, blocking and power on the plans.
Start a project togetherThe before-drywall checklist
- Which windows get motorized shades, and which stay manual.
- Pocket and blocking details for each opening.
- Who pulls which wire, and where the power for wired shades comes from.
- Keypad and control locations, marked on the plan.
- Measurements taken again before finish, so every shade fits the opening as built.
A scope your superintendent can trust
One scope sheet per home says what we do and when we are on site, so nothing lands on the superintendent at the end.
We design, install, configure and program the lighting control.
How a home runs with us
- You send the plans for the home or the phase.
- We mark each opening's shade, pocket, blocking and power needs and send them back for your team.
- We check the openings at framing and measure again before finish.
- Our crews install after finishes, set every shade and hand over to the owner.
Questions and answers
Do you work on custom homes and on tracts?
Both. A custom home gets a plan for every opening; on a tract, each floor plan in the phase gets its own shade plan.
Can you work from plans before the site is ready?
Yes. Send the plans and we return them marked with what each opening needs, so your trades can build it in.
When should we bring you in?
At framing, or at the electrical walk-through. That is when power, pockets and blocking for wired shades are simple to plan.
Start a project together
Tell us about the project and we will call you back.